Skip to content
Psi to Psia logo Psi to Psia
Everyday math

Rounding Numbers the Right Way

Round half up or half to even, decimal places vs significant figures, and why you should round only at the end. Worked examples and a rounding checklist.

By Psi to Psia Team
Rounding Numbers the Right Way

Rounding makes numbers easier to read, but rounding too early or with the wrong rule changes the answer. Look at the digit after the place you are rounding to: 5 or more rounds up, 4 or less rounds down.

Round half up

This is the rule most people learn at school.

  • 3.46 rounded to 1 decimal place is 3.5, because the next digit is 6.
  • 3.44 rounded to 1 decimal place is 3.4, because the next digit is 4.
  • 2.5 rounded to a whole number is 3.

Round half to even

Accountants, scientists and many programming languages use round half to even, also called banker’s rounding. When a value is exactly halfway, it rounds to the nearest even digit: 2.5 → 2, 3.5 → 4. Over many values, this stops the totals from drifting upward.

Decimal places vs significant figures

  • Decimal places count digits after the decimal point. 0.004567 to 2 decimal places is 0.00.
  • Significant figures count digits starting from the first non-zero digit. 0.004567 to 3 significant figures is 0.00457.

Use significant figures for measurements of very different sizes, and decimal places for money.

Round once, at the end

Rounding in the middle of a calculation adds error at every step. Take 1/3 rounded to 0.33, then multiplied by 3: the answer is 0.99, not 1. Keep full precision until the final answer, then round once.

Unit conversions show the same effect. An inch is exactly 2.54 cm, so 12 inches is 2.54 × 12 = 30.48 cm. Rounding 2.54 to 2.5 first gives 30 cm, which is off by nearly half a centimeter. The Centimeters to Inches converter keeps the exact factor and rounds only the displayed result.

Pressure readings

The PSI to PSIA calculator adds 14.696 psi of sea-level atmospheric pressure. Rounding that constant to 14.7 changes every result by 0.004 psi — negligible for tires, but worth keeping for lab or calibration work.

A rounding checklist

  • Decide the precision you need before you start: cents for money, the instrument’s resolution for measurements.
  • Use exact constants during the calculation.
  • Round once, at the end.
  • Say which rule you used when it matters, especially for values that end in 5.

For percentages that end in repeating decimals, such as 33.33%, see Converting Fractions, Decimals and Percentages.